JAG3D Introduction (Software)

Milos @, Freitag, 24. November 2017, 20:03 (vor 17 Tagen) @ Micha

Thank you for your explanation Micha.

Let me introduce you with my 'simple' student task...
I'm supposed to adjust 2d 4 point network with 12 measured directions and the same 12 measured distances.
Datum should be defined with Y1, X1 and Y2. How to perform that action?
From your previous message, I understood that I should store these 4 approximated points in the new points, am I right?

P.S. I guess this software works with classical way of defining datum parameters, am I right?
What about min trag defining of datum parameters?

Kind regards,
Milos


gesamter Thread:

 RSS-Feed dieser Diskussion